Special Tools - Toro Greensmaster
Flex 18 04018 Service Manual

Special Tools

Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS).
Gauge Bar Assembly
Toro Part Number: 13–8199
Used to verify height–of–cut.
Backlapping Brush Assembly
Toro Part Number: TOR299100
Used to apply lapping compound to cutting units while
keeping the operator's hands at a safe distance from the
rotating reel.
Bedknife Screw Tool
Toro Part Number: TOR510880
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a 3/8" drive torque
wrench to secure the bedknife to the bedbar.
DO NOT use an air or manual impact wrench with this
tool.
Roller Bearing Installation Tools
Washers and spacer used to install bearings and seals
into front and rear rollers.
Seal installation washer (black): 107–8133
Seal installation spacer: 107–3505
Bearing installation washer (yellow): 104–6126
Cutting Unit
Some tools may have been supplied with your mower or
are available as TORO parts. Some tools may also be
available from a local supplier.
Seal Installation
Washer
Page 7 – 4
Figure 4
Figure 5
Figure 6
Bearing Installation
Seal Installation
Washer
Spacer
Figure 7
Greensmaster Flex 18/21