Grooming Brush - Toro Greensmaster
Flex 18 04018 Service Manual

Grooming Brush

20 to 25 in–lb
(2.3 to 2.8 N–m)
1. Grooming brush shaft
2. Lock nut
The grooming brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
the grooming brush use the same procedure as removal
and installation of the grooming reel (see Grooming
Reel in this section).
To remove the grooming brush from the shaft, remove
the lock nut and J–bolt from both ends of the brush.
While retaining the shaft, rotate the brush and slide from
the shaft. When assembling the brush to the shaft, se-
cure the assembly with J–bolts and lock nuts. Make sure
that the J–bolts are installed with the threaded portion
on the outside of the brush (Fig. 21). Torque lock nuts
from 20 to 25 in–lb (2.3 to 2.8 N–m).
Groomer
2
4
3. J–bolt
3
1
Figure 20
1. J–bolt
Page 8 – 18
3
20 to 25 in–lb
(2.3 to 2.8 N–m)
2
4. Grooming brush
1
2
Figure 21
2. Lock nut
Greensmaster Flex 18/21