Toro Greensmaster
Flex 18 04018 Service Manual page 91

C. If cutting unit is equipped with a groomer, remove
LH groomer side plate (see Groomer Reel Bearing
Replacement in the Service and Repairs section of
Chapter 8 – Groomer).
D. Locate and retrieve three (3) spacers (items 4
and 5) from between reel drive plate and side plate.
7. Remove front and rear rollers from cutting unit (see
Roller Removal in this section).
8. Support reel weight on right side of the cutting unit to
prevent it from falling. Remove two (2) cap screws and
flat washers that secure weight. Remove reel weight
from cutting unit.
NOTE: The reel bearing lock nut has left hand threads.
9. Block reel with a piece of wood to prevent reel from
turning. Remove reel bearing lock nut from right side of
reel.
10.Remove cap screw, flat washer and lock nut that se-
cures grass shield to RH side plate.
IMPORTANT: Support reel to prevent it from falling as
side plate is removed.
11. Remove two (2) shoulder bolts and square nuts that
secure RH side plate to crossmember (Fig. 32). Slide
RH side plate and pitch arm from reel shaft.
12.Slide cutting reel from the LH side plate and cutting
unit.
13.If necessary, remove LH side plate and pitch arm
from crossmember and grass shield.
14.Refer to Cutting Reel Service in this section for infor-
mation on reel inspection and wear sleeve and v–ring
seal service.
Cutting Reel Installation (Fig. 29)
1. Use a flat level surface or a stable work bench to
install cutting reel.
2. If separated, attach LH side plate to crossmember
with two (2) shoulder bolts and square nuts (Fig. 32).
Torque shoulder bolts from 210 to 240 in–lb (23.7 to
27.1 N–m). Make sure that LH pitch arm is installed on
bushing on side plate.
3. Apply antiseize lubricant to bearing journals of cut-
ting reel.
4. Make sure that wear sleeve and v–ring seal are prop-
erly installed on both ends of reel shaft (see Cutting Reel
Service in this section).
5. Apply grease to lips of grease seals in side plates to
ease reel installation.
Greensmaster Flex 18/21
3
2
1. Cap screw w/lock washer
2. Cap screw w/flat washer
9
3
Antiseize
4
Lubricant
1. Flange nut
2. Drive pulley (22 tooth)
3. Lock nut (2 used)
4. Spacer (2 used)
5. Spacer
6. Lock washer
210 to 240 in–lb
(23.7 to 27.1 N–m)
1
2
1. Crossmember
2. Shoulder bolt (4 used)
3. RH side plate
4. Square nut (4 used)
Page 7 – 21
1
2
Figure 30
3. LH cutting reel sideplate
40 to 50 ft–lb
5
(54 to 68 N–m)
12
6
7
8
11
10
2
Figure 31
7. Cap screw
8. Reel drive plate
9. Woodruff key
10. Cap screw (2 used)
11. Flat washer (2 used)
12. Seal spacer
7
4
3
Figure 32
5. LH side plate
6. Nylon bushing
7. Rubber bushing
Cutting Unit
1
6
5