Connecting An Wireless Lan Access Point; Table 7.2 Specification For Wireless Lan Equipment Connection - Samsung OfficeServ 7400 Installation Manual

Pin No. 1
Function Tx+
The use of LIM port as an Uplink required the use of a twisted LAN cable.
7.1.4.2 Mounting Gigabit module of Switching board
GLIMP, GSIM, GWIM boards provide Gigabit Interface, and by using the SFP (Small
Form-factor Pluggable) Connector, support all 1000BASE-TX/SX/LX. Therefore, it is
important to mount the correct specification of Gigabit Interface Module, and connect each
other with the same kind of cables.
1000BASE-TX SFP Module - UTP Cable
1000BASE-SX - MMF Optic Cable
1000BASE-SX - SMF Optic Cable

7.1.5 Connecting an Wireless LAN Access Point

Wireless LAN service offered by the OfficeServ 7400 system requires the following
equipment: 4WLI board:
WLI Board: A board mounted on the OfficeServ 7400 system for WBS24 connection
WBS24: Wireless LAN Access Point(AP)
WIP-5000M: Wireless LAN IP phone

Table 7.2 Specification for Wireless LAN Equipment Connection

Items
Numbers of 4WLI Boards
Max. Numbers of WBS24
Max. Numbers of Users
Numbers of Simultaneous Users
Installation and Usage of WBS 24 and WIP-5000M
For information on how to install and use WBS24 and WIP-5000M, refer to
'OfficeServ Wireless LAN Service Manual' and 'WIP-5000M User Guide'.
© SAMSUNG Electronics Co., Ltd.
2 3 4
Tx- Rx+ -
(Both of Basic Cabinet and Basic + Expansion Cabinet.s)
OfficeServ 7400 Installation Manual
5 6
- Rx-
RJ-45 포트
OfficeServ 7400 System
3
12
120
48
7 8
- -
7-9