Canon PIXMA MX860 series Getting Started page 28

•
•
~
..
Go to Step €).
Go to Step
0.
Windows Vista
Windows
Windows XP/2000
The setup program should start automatically.
Turn on the computer, then insert the Setup CO-
ROM into the CD-ROM drive.
• If the program does not start automatically, double-click the
CD-ROM icon on the computer. When the CD-ROM contents
appear, double-click MSETUP4.EXE.
w _
c c
A
TURN OFF THE MACHINE (A).
o
• Operating noise continues for about 30 seconds
until the machine turns off. Make sure that the
mode button (8) stops flashing.
Setup the Machine and the Computer
Locate and install driver software (recommended)
Windows wlH gUide you through the
proc~
of installing dnvrr software
for your
devlce.
Dont show this message again for this device
Your devtQ Will not function until you Inn.!f dnver software.
.. Ask me again later
Windows WIll ask agllin the nm time you plug
In
your device or log on,
Remove the USB cable connected to
your computer.
The dialog box may close. In this case, proceed
from step
O.
Click Cancel to quit the dialog box.
Proceed from step
O.
If the Found New Hardware or Found New
Hardware Wizard dialog box appears:
1
2
3
• •
• •
• •
I
I