2C-30 Rear Suspension:
4) Install trailing rod to rear suspension knuckle and
then tighten trailing rod rear bolt (1) temporarily by
hand.
CAUTION
!
If reuse trailing rod rear bolt, apply engine oil
to thread, bearing and trunk surface.
1
5) Install control rod to rear suspension knuckle tighten
control rod outer bolt (1) temporarily by hand.
CAUTION
!
If reuse control rod outer bolt, apply engine
oil to thread, bearing and trunk surface.
6) Remove floor jack from lower arm.
7) Install rear brake hose bracket (1) and then tighten
rear brake hose bracket bolt (2) to specified torque.
Tightening torque
Rear brake hose bracket bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
I5JB0A230070-01
8) Install ABS wheel sensor (1) (if equipped) and then
tighten wheel sensor bolt (2) to specified torque.
Tightening torque
Wheel sensor bolt (a): 11 N·m (1.1 kgf-m, 8.0 lb-
ft)
1
I5JB0A230069-01
9) Install rear wheel hub assembly referring to "Rear
Wheel Hub Assembly Removal and Installation: ".
10) Fill reservoir with brake fluid and bleed brake
system. Refer to "Air Bleeding of Brake System: in
Section 4A".
1
1
2,(a)
2,(a)
I5JB0A230074-01
I5JB0A230075-01