Rear Suspension Frame / Bushing Disassembly And Assembly - Suzuki GRAND VITARA Owner's Manual

12) Install control rod referring to "Control Rod Removal
and Installation: ""Control Rod Removal and
Installation: ".
13) Install rear wheel hub assembly referring to "Rear
Wheel Hub Assembly Removal and Installation: ".
14) Connect rear propeller shaft to differential aligning
match marks on flanges. Tighten bolts and nuts to
specified torque. Refer to "Propeller Shaft Removal
and Installation: in Section 3D".
15) Install exhaust muffler and exhaust center pipe
referring to "Exhaust System Components: in
Section 1K".
16) Fill reservoir with brake fluid and bleed brake
system. Refer to "Air Bleeding of Brake System: in
Section 4A".
17) Upon completion of all jobs, depress brake pedal
with about 30 kg (66 lbs) load three to five times so
as to obtain proper drum-to-shoe clearance. Adjust
parking brake cable. Refer to "Parking Brake Check
and Adjustment: in Section 4D".
18) Install rear wheels.
19) Check to ensure that brake drum is free from
dragging and proper braking is obtained.
20) Lower hoist and tighten rear wheel bolts to specified
torque.
Tightening torque
Wheel nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
21) Bounce vehicle up and down to stabilize suspension.
22) Tighten each bolts and nuts to specified torque with
vehicle weight on suspension.
NOTE
It is the most desirable to have vehicle off
hoist and in non-loaded condition when
tightening them.
23) Perform brake test (foot brake and parking brake).
24) Check each installed part for fluid leakage.
25) Check rear toe and camber and adjust it if
necessary. For check and adjustment procedures,
refer to "Rear Wheel Alignment Inspection and
Adjustment: ".
26) Adjust headlight auto leveling system, referring to
"Initialization of Auto Leveling Headlight System: in
Section 9B".
Rear Suspension frame / Bushing Disassembly
and Assembly
Disassembly
1) Cut rubber (1) of flange of rear suspension frame
bushing.
2) Using grinder (2), grind off flange (3) of upper arm
bushing.
CAUTION
!
Be careful not to damage rear suspension
frame bushing (4) when grinding flange (3) of
upper arm bushing with grinder.
3) Push out rear suspension frame bushing by using
hydraulic press (1) and special tool.
Special tool
(A): 09913–75520
1
(A)
Rear Suspension: 2C-23
S5JB0A2306037
I5JB0A230054-02
I5JB0A230055-02