Suzuki GRAND VITARA Owner's Manual page 595

Stabilizer Joint
1) Check for smooth rotation.
2) Check damages of ball stud.
3) Check damages of dust cover.
NOTE
Stabilizer joint (1) cannot be disassembled.
If there is any damage to either parts, stabilizer joint
assembly must be replaced as a complete unit.
Tightening Torque Specifications
Fastening part
Tie-rod end lock nut
Strut bracket nut
Brake hose mounting bolt
Stabilizer joint nut
Front wheel speed sensor harness clamp bolt
Strut support nut
Wheel nut
Strut nut
Wheel hub housing bolt
Caliper carrier bolt
Drive shaft nut
Suspension arm ball joint nut
Front wheel speed sensor bolt
Tie-rod end nut
Suspension control arm ball joint nut
Suspension control arm nut
Stabilizer bar mounting bracket bolt
Suspension frame mounting bolt
Engine front body side mounting nut
Pipe bracket bolt
Union gear box bolt
NOTE
The specified tightening torque is also described in the following.
"Front Suspension Construction: "
"Front Strut Assembly Components: "
"Front Wheel Hub Assembly and Steering Knuckle Components: "
"Front Suspension Frame, Stabilizer Bar and/or Bushings Components: "
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information: in Section 0A".
Front Suspension Fasteners Check
Check each bolt and nut fastening suspension parts for
tightness. Tighten loose one, if any, to specified torque,
referring to "Front Suspension Construction: ".
Specifications
Tightening torque
N⋅m kgf-m
65 6.5
135 13.5
25 2.5
60 6.0
10 1.0
50 5.0
100 10.0
90 9.0
50 5.0
85 8.5
200 20.0
55 5.5
10 1.0
45 4.5
55 5.5
45 4.5
50 5.0
135 13.5
55 5.5
11 1.1
35 3.5
Front Suspension:
1
I4RH01220007-01
S5JB0A2206018
S5JB0A2207001
Note
lb-ft
47.0
98.0 /
18.0
43.5 /
7.5
36.5
72.5 / / /
65.0
36.5
61.5
145.0 /
40.0
7.5
32.5 /
40.0
32.5
36.5
98.0
40.0
8.0
25.5
2B-23