Panasonic KX-NCP500 Programming Manual page 14

1.2.1 Installing and Starting the Maintenance Console
After Quick Setup is completed, if the IP addressing information was not changed and a
V-IPEXT card was installed during setup, the IP-PT registration screen is displayed. For
information on registering IP-PTs to the PBX, see 3.15 [1-1] Slot—Port Property - Virtual IP
Extension.
You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the MPR and DSP cards once IP telephones are registered to the
PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the DHCP
server when DHCP Client is set to Enable. In this case, you need to consult your network administrator
because the DHCP server on your network may not be running or a network failure may have occurred.
If the DHCP server is not available, change the DHCP Client setting to Disable and set fixed IP
addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet straight
cable. When connecting the PC with an Ethernet straight cable, make sure the PBX is disconnected
from the LAN and then connect the PC with an Ethernet straight cable using 192.168.0.101 for the IP
address of the MPR card.
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
*3 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*4 Valid IP address range: "0.0.0.0" to "223.255.255.255"
PBX Web Manager
It is possible to use a PC with the Maintenance Console (PBX Unified PC Maintenance Console) installed, as
a Web server. This allows users to configure the PBX via a Web browser on a local client, or a remote PC
through the Internet.
If Maintenance Console is installed on the client PC, a Web server is not necessary.
14 PC Programming Manual
PBX Server
PBX
Client
IP Network
Remote PC
Server/Client
Document Version 2011-10