JVC CX-7000 Series Electronic Manual page 95

IC
Non-contact IC encode
Allows writing of data to a non-contact IC.
Contact IC encode
Allows writing of data to a contact IC.
Turns over the card after IC encoding
Turns over the card after writing data to the non-contact/contact
IC.
Magnetic
Magnetic encode
Allows writing of data to the magnetic stripe.
Turns over the card after MG encoding
Turns over the card after writing data to the magnetic stripe.
Write Retry
For setting the maximum number of retries when writing to or
reading of the magnetic stripe fails.
When the [Default] is selected, the retry counter uses the preset
value of the printer.
Coercivity
Coercivity of the magnetic stripe card.
When the [Default] is selected, the coercivity uses the preset value
of the printer.
Starts from magnetic encoding
Unchecked : Encodes in the ICNMagnetic sequence.
Checked : Encodes in the MagneticNIC sequence.
Prints after encoding
Unchecked : Starts printing while encoding is in progress.
Checked : Starts printing after encoding is complete.
[Configuration] Tab
.
Memo:
These settings can be altered only when the user logs into the
printer driver settings page with administrator authority
(Administrators group).
This tab is displayed in the read-only mode when a user without
administrator authority logs in.
Optional configuration
For specifying whether the options are installed.
Turn over unit
Bend remedy unit
Non-contact IC encoder
ISO Contact IC encoder
JIS Contact IC encoder
ISO Magnetic encoder
JIS Magnetic encoder
Laminator
Enable the settings
Permits or forbids the [Enable the printer settings] functions in the
[Print] tab.
Printer settings
Unchecked : Forbids the [Enable the printer settings] functions in
the [Print] tab.
Checked : Permits the [Enable the printer settings] functions in
the [Print] tab.
"Enable the printer settings" (A page 88)
Cautions:
When a user logs in with administrator authority (Administrators
group), the [Configuration] settings can be specified.
If a user logs in without administrator authority, the [Configuration]
settings appear in the read-only mode, and they cannot be specified.
[Version] Tab
Displays the version and copyright information.
.
Setup
95