JVC CX-7000 Series Electronic Manual page 53

If the card is inside the printer unit
If the card is not drawn into the card feed roller and is left inside
the printer, use the tweezers (supplied) to remove the card.
A Turn off the power
B Check the position of the card that is left inside the printer
.
C Pick up the card using the tip of the tweezers (supplied)
Be careful not to drop the card inside the printer.
D Pull out the card slowly
.
Cautions:
The card may be very hot. Be careful not to burn your fingers
when removing the card.
If the card cannot be removed, do not try to do so forcibly.
Consult our authorized dealers or the servicing personnel.
Memo:
Example of how to pick up the card
.
Pick up the card by following the diagram above.
E Install the retransfer film cassette, and close the printer door
.
F Turn on the power
"Go to step 5" (A page 52)
If the card is caught in the card feed roller to the right of the
retransfer heating roller
A Turn off the power, and detach the card hopper
.
B Check the position of the card
C Attach the jog dial to the card feed roller shaft and cleaning
roller shaft
.
.
D Turn the card feed roller shaft and cleaning roller shaft in the
clockwise direction, while checking the position of the card
.
Remove the card after it is discharged from the card load slot.
(For single-sided printers, the card is discharged from the NG
card outlet.)
Cautions:
If the card cannot be removed, do not try to do so forcibly.
Consult our authorized dealers or the servicing personnel.
E Restore the jog dial to its original position, and install the card hopper
F Install the retransfer film cassette, and close the printer door
G Turn on the power
"Go to step 5" (A page 52)
Troubleshooting
53