Normal Dubbing (From Vhs To Hdd) - JVC 0503-AH-ID-JVE Instructions Manual

66
EN
Normal Dubbing
(from VHS to HDD)
?
You can dub selected scenes from a cassette to the HDD deck,
starting and stopping wherever you wish.
A
Load a cassette.
Insert a cassette with the record safety tab intact.
B
Prepare the VHS deck for dubbing.
A Slide TV/CABLE/SAT to the right, then press S-VHS
and select the programme to be dubbed. You can
select the programme by VCR Navigation. (
B Press VCR PR+/– to set the channel other than "DUB".
Set "PICTURE CONTROL" to "EDIT" (
C
Locate the start point.
A Search for the point where you want to start dubbing
by pressing 4, 5 or 3 then press 8.
B Press 3 a little, then press 4 to start playback.
C Press 9 to pause playback a little before the start
point.
D
Prepare the HDD deck for dubbing.
A Press HDD.
B Press VCR PR+/– to set the channel "DUB".
C Press MODE to select recording speed.
E
Start dubbing.
A Press S-VHS and
to start playback.
4
B Press HDD and
(
7 7
start dubbing.
To enter Record-Pause mode, press and hold
on the remote control. To resume recording, press and hold
and press on the remote control.
4
F
End dubbing.
Press twice. Then press S-VHS and press
8
NOTES:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
The superimposed indication during the operation or dubbing
is not recorded.
For HDD deck, the recording pause takes effect only when the
recorder is recording on the HDD deck with the channel set to
"L-1", "F-1", or "DUB". The recording pause is released in 5
minutes automatically. Picture and sound may be distorted at
the point where the recording pause is released.
Dubbing copyright guarded tape is not possible.
When you select "EDIT" to dub tapes in step B, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
EDITING (cont.)
pg. 83).
and on the remote control) to
4
and press
7
.
8
pg. 36)
9
7