Scan Mode Set; Tray Lock (Dvd Deck Only) - JVC DR-MV1B Instructions Manual

Filename [DR-MV1SEK_10Subsidiary.fm]
DR-MV1SEK_10Subsidiary.fm Page 89 Thursday, April 22, 2004 6:38 PM

Scan Mode Set

If you connect the unit and TV with Component Video Connection
( pg. 18), you can select the scan mode from two modes:
Interlaced scan mode which is used in the conventional TV
system, and Progressive scan mode which enables reproduction of
higher-quality images. For details, refer to "GLOSSARY"
( pg. 95).
ATTENTION:
Your TV needs to be compatible with PAL Progressive.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
VCR/DVD
1
4
7
1
Press VCR/DVD repeatedly so that the DVD lamp lights up on
the unit.
2
Press PROGRESSIVE SCAN for 3 or more seconds.
Video output indicator ( ) lights on the front display panel if
Progressive scan mode has been established. (
Each press of PROGRESSIVE SCAN for 3 or more seconds
switches the scan mode.
NOTES:
When the progressive mode is set, be sure to set "L-1 OUTPUT" to
"COMPONENT". ( pg. 74) Progressive scan is output only from
COMPONENT VIDEO OUT connector.
Interlaced scan mode is the setting at your purchase.
Interlaced scan mode might be suitable depending on video material.
Scan mode cannot be set while menu screen is displayed.
When the Progressive scan mode is engaged, no video signal is
output from S-VIDEO OUT connector and L-1 IN/OUT connector.
Watch the image on VCR deck in the Progressive scan
mode via component video
A Set the Progressive-compatible TV to the component input
mode.
B Press VCR/DVD repeatedly so that the DVD lamp lights up
on the unit, then press PROGRESSIVE SCAN for 3 or more
seconds so that the Video output indicator (
display panel.
C Press VCR/DVD repeatedly so that the VCR lamp lights up
on the unit.
D Press VCR].
"VCR]" lights up on the unit.
E Insert a cassette and press 4.
NOTES:
Be sure to engage the DVD deck in stop mode.
It is not possible to perform the above steps when the DVD deck is
in timer standby mode.
If the image and sound is distorted, press VCR/DVD repeatedly.
Page 89
SAT
2 3
5 6
8 9
0
PROGRESSIVE SCAN
pg. 14)
) lights on the front
Masterpage:Right+

Tray Lock (DVD Deck Only)

You can lock the disc tray to prohibit the unwanted disc ejection by
children.
Turn off the unit when the DVD deck is selected.
To lock tray
While the unit is turned off, press and hold 8, then press x on the
unit. "LOCKED" appears on the front display panel and the disc
tray is locked.
To unlock tray
While the unit is turned off, press and hold 8, then press x on the
unit. "UNLOCK" appears on the front display panel.
SUBSIDIARY SETTINGS
89
EN
8
x
April 22, 2004 6:32 pm