Preparations For Installation; Installation Of Operating System; Table 4.2 Operating System Installation Using Svim - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software
4.4 Procedures to install Windows into internal HDD/SSD
- For the UEFI Install
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "EFI Compatible
ROM".
- For the UEFI Install:
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "Legacy ROM".
- Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to "Enable"
only for booting Device.
4. The I/O space is allocated in the SAS card and in the SAS RAID controllerRAID card.
For details on allocation of I/O space, see
menu" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).

4.4.2 Preparations for installation

The following preparations are done.
1. The following disk images are prepared.
Media of Windows operating system
2. Remove all FC cables.
3. Mount the following disk image by connecting the video redirection.
4. Change the boot order, and set DVD Boot to the top priority of the starting order.
For details, see "1.3.1 [Power Control] window" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).

4.4.3 Installation of operating system

This section explains the installation of operating system using SVIM.
There are the following types of operating system installations using SVIM.
For the detailed procedures of each mode, see ServerView Suite ServerView Installation Manager.
Mode
Quick You can simply use the minimum settings necessary for operating
mode system installation. This mode uses Fujitsu's recommended settings.
Guide You can specify setup information by following the instructions of the
mode wizard. You can save the specified information in a configuration file for
use during reinstallation.
All the screenshots are the display examples. Contents displayed may differ depending on system configuration.
Operations
1. If setting is done, you can boot the ServerView Suite DVD from virtual media for the partition.
For details on configuration, see"1.6.2 Remote control operation (BMC)" of PRIMEQUEST 2000 series
Administration Manual (CA92344-0537).
2. The power supply of the partition is turned ON.
Note
It can be started by selecting "Force boot from DVD" by Boot Selector or it can be started from the virtual media by
changing the boot order to DVD by UEFI.
When operating system corresponds to the UEFI mode, the installation can be done in UEFI mode by changing the
boot order according to the following procedure.
a. After turning on the power supply of the partition, while the FUJITSU logo is displayed, press any key (such as
[Space] key) except [Enter] key and the Boot Manager front page is displayed.
b. The menu is selected on the Boot Manager front page in the following order. [Boot Maintenance Manager]-
[Boot Options]-[Change Boot Order]-[Change the order]
c. For UEFI aware OS, UEFI: Fujitsu Virtual CDROMx xxx is set at the upper-most step.
For Legacy OS, Fujitsu Virtual CDROMx xxx is set at the upper-most step.
"3.4.5 Various mode
Operating System Installation using SVIM
TABLE 4.2
Functional Overview
settings" and [Configure I/O Space Assignment]
For easy installation.
For detailed setting of RAID or
OS.
66
Purpose
CA92344-0536-01