Preparation Of Installation; Vmware 5.X Installation; Table 4.6 Operating System Installation By Svim - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software
4.8 Procedure to install VMware 5.x into internal HDD/SSD
ROM".
- For the UEFI Install:
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to "Legacy ROM".
- Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to "Enable"
only for booting Device.
3. The I/O space is allocated in the SAS card and in the SAS RAID controllerRAID card.
For details on allocation of I/O space, see
menu" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
4. Set PCI Address Mode to PCI Bus Mode through MMB Web-UI.
For details on PCI Address Mode setting, see "1.3.8 [Partition#x] Menu" of PRIMEQUEST 2000 series Tool
Reference Manual (CA92344-0539).

4.8.2 Preparation of installation

See the VMware information thoroughly at the time of installation preparation.
For the VMware product, please contact who you purchased the product from.
Set the following.
1. The following disk images are prepared.
VMware 5.x media
2. Remove all FC cables.
3. Mount the following disk image by connecting the video redirection.
4. Configure the RAID environment.
For details, see the MegaRAID SAS Software, the MegaRAID SAS Device Driver Installation, or the LSI MegaRAID
(R) SAS Software contained on the SVS DVD.
5. Change the boot order, and set DVD Boot to the top priority of the starting order.
For details, see "1.3.1 [Power Control] window" of PRIMEQUEST 2000 series Tool Reference (CA92344-0539).

4.8.3 VMware 5.x installation

This section describes the installation of the operating system by SVIM.
The type of the operating system installation by SVIM includes the following types. For the detailed procedure of the
concerned mode, see ServerView Suite ServerView Installation Manager.
Mode
Quick mode
Guide mode
All the screenshots are display examples and the displayed contents differs depending on the system configuration.
Operations
1. The settings are done to boot the ServerView Suite DVD from virtual media for the partition.
For details on configuration, see"1.6.2 Remote control operation (BMC)" of PRIMEQUEST 2000 series
Administration Manual (CA92344-0537).
2. The power supply of the partition is turned ON.
Note:
It can be started by selecting "Force boot from DVD" by Boot Selector or it can be started from the virtual media by
changing the boot order to DVD by UEFI.
When operating system corresponds to the UEFI mode, the installation can be done in UEFI mode by changing the
boot order according to the following procedure.
Operating system installation by SVIM
TABLE 4.6
Functional Overview
You can simply use the minimum settings
necessary for operating system installation.
This mode uses Fujitsu's recommended
settings.
You can specify setup information by following
the instructions of the wizard. You can save the
specified information in a configuration file for
use during reinstallation.
"3.4.5 Various mode settings" and [Configure I/O Space Assignment]
Purpose
For easy installation.
For detailed setting of RAID or OS.
79
CA92344-0536-01