Yamaha ’09 YZF-R1 Kit Manual page 61

• The switch installed to the STD machine may be used as is. (See diagram 3.)
(Digram 3)
Pit road limiter
ON OFF
Not used
Map select
Lo → Map 1
Hi → Map 2
Pit road limiter
ON ON
PUSH=OFF
Shifter switch
• The shifter switch function can be used by combining the harness and kit ECU.
To use the STD switch (left side) to function as the shifter switch, connect the wire sub-
1
lead that was packaged with this set to the terminal that is normally connected to the left
side horn. (See diagram 4.) However, if the resistor assembly is not installed, there is the
possibility that the shifter switch will operate incorrectly in rainy weather. (See diagram
5.)
NOTICE
Do not bend the resistor assembly. It will cease to function if it is bent.
Install the switch to the 2-pin black coupler underneath the fuel tank. Turning the switch
2
ON cuts the ignition.
(Diagram 4)
Main switch
– 58 –
(Diagram 5)
Engine stop
switch
Starter
switch
5