2-2. Replacement of CCD Unit Boards
When replacing the boards in the CCD unit, remove the
CCD unit from the main unit in advance.
For removing the CCD unit, refer to Section 2-1.
n
Be careful not to bend the flexible card wire. This shortens
the wire life. (Refer to Section 1-10.)
2-2-1. DR-528 Board
1. Remove the five screws to detach the OHB cover.
(Refer to Section 2-2-2.)
2. Disconnect the flexible card wires from the connectors
(CN1, CN2) on the DR-528 board.
3. Remove the three screws to remove the DR-528 board.
Install the board by reversing the steps above.
2-4
B2 x 4
CN1
CN2
DR-528 board
2-2-2. CN-2579 Board
1. Remove the five screws to detach the OHB cover.
2. Disconnect the flexible card wires from the connectors
(CN1, CN2) on the CN-2579 board.
3. Remove the three special screws to remove the CN-
2579 board.
Install the board by reversing the steps above.
B2 x 4
OHB cover
B2 x 4
B2 x 4
CN1
CN-2579 board
Special
screws (M2)
CN2
HDC1000/V1(E)