Samsung SRP-275 Operator's Manual page 88

CHAPTER 5
CONTROL COMMANDS LIST
SI
[Name] Select upside-down printing
[Format] ASCII SI
Hex 0F
Decimal 15
[Range] ------
[Default] Upside-down printing cancelled
[Description] Specifies upside-down printing
This command is enabled only when at the top of the line.
Therefore, upside down and right-side up characters cannot both exist in the
same line.
This command is enabled for following.
- ANK characters
- Chinese characters
- Bit-Image
DC2
[Name] Cancel upside-down printing
[Format] ASCII DC2
Hex 12
Decimal 18
[Range] ------
[Default] Upside-down printing cancelled
[Description] Cancels upside-down printing
This command is enabled only when at the top of the line.
5-84
ESC RS i n
[Name] Specify/cancel character rotate mode
[Format] ASCI ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 2
[Range]
48 ≤ n ≤ 50 ("0" ≤ n ≤ "2")
[Default] Character rotation cancelled (n = 0)
[Description] Specifies direction to rotate print (clockwise) or to cancel rotation for
subsequent data, according to the n value.
n Set rotation
0, 48 Cancelled (0° rotation)
1, 49 270° rotation
2, 50 90° rotation
Rotated characters cannot be applied with underlines or upperlines.
The relationship between double-high and double-wide is reverse to when
cancelled when rotating.
Cautions when character fonts
- Characters are printed using 7 x 9 fonts.
- Registered characters are printed using 7 x 9 font for download
characters as well.
- Double height of character is not available when in character rotate mode.
- This command is recommended not to use because print quality is
not guaranteed.
RS i n
1E 69 n
30 105 n
5-85