Samsung SRP-275 Operator's Manual page 46

CHAPTER 5
CONTROL COMMANDS LIST
ESC E
[Name] Turn emphasized mode on/off
[Format] ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 255
[Range]
[Default] n = 0
[Description] Turns emphasized mode on or off.
- When the LSB of n is 0, emphasized mode is turned off.
- When the LSB of n is 1, emphasized mode is turned on.
[Notes] This mode is effective for alphanumeric, multilingual,
and user-defined characters.
The settings of this command are effective until ESC ! is executed,
ESC @ is executed, the printer is reset, or the power is turned off.
ESC G
[Name] Turn double-strike mode on/off
[Format] ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 255
[Range]
[Default] n = 0
[Description] Turns double-strike mode on or off.
- When the LSB of n is 0, double-strike mode is turned off.
- When the LSB of n is 1, double-strike mode is turned on.
5-22
E n
45 n
69 n
G n
47 n
71 n
ESC J
[Name] Print and feed paper
[Format] ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 255
[Range]
[Default] None
[Description] Prints the data in the print buffer and feeds the paper n.
(vertical unit).
[Notes] After printing, the printing position moves to the beginning of the line.
The position of the left margin is the beginning of the line.
This command is used to temporarily feed a specific length without changing
the line spacing set by other commands.
The vertical motion unit is 0.176 mm (1/144 inch) (the minimum movement amount).
This value equals a half dot pitch.
ESC K
[Name] Print and reverse feed
[Format] ASCII ESC
Hex 1B
Decimal 27
0 ≤ n ≤ 24
[Range]
[Default] None
[Description] Prints the data in the print buffer and feeds the paper n x (vertical motion unit)
in the reverse direction.
[Notes] After printing, the printing position moves to the beginning of the line.
When a left margin is set, the position of the left margin is the beginning of the line.
The vertical motion unit is used.
This command is used to temporarily feed a specific length without changing
the line spacing set by other commands.
This command must not be executed consecutively more than one time.
The vertical motion unit is 0.176 mm (1/144 inch) (the minimum movement amount).
This value equals a half dot pitch. In the reverse direction, the maximum paper feed
amount is 4.23 mm (24/144 inch). If the specified amount exceeds 4.23 mm
(24/144 inch), the printer only prints the data and does not feed the paper.
J n
4A n
74 n
K n
4B n
75 n
5-23