Samsung SRP-275 Operator's Manual page 81

CHAPTER 5
CONTROL COMMANDS LIST
ESC & <0> n1 n2 [m0 m1 m5 m6 m7 m8 m9] n2 — n1 +1
[Name] Defining the download character set
[Format] ASCII ESC
Hex 1B
32 ≤ n1 ≤ n2 ≤ 255, m0 = 0 or m0 = 128
[Range]
[Description] This command defines he download characters. n1 is a character code to start
definition and n2 is to end definition, respectively. When defining only one
character, set n1 = n2. You can define the ASCII codes ranging from 32 to
255. Once the download characters are defined, they remain valid until they
are redefined or the download deletion command (ESC DC2 n1 n2) is
executed.
5-138
& <0> n1 n2 [m0 m8 m9] n2-n1+1
26 00 n1 n2 [m0 m8 m9] n2-n1+1
ESC % n
[Name] Specifying/Canceling the download character set
[Format] ASCII ESC % n
Hex 1B 25 n
[Description] This command selects/deselects the download character set. The download
characters cannot be printed by simply defining them with the above-
mentioned ESC & 0 command. To print them, send this command to the
printer.
n Download Character Set
0
Deselect
30
1
Select
31
ESC / n "data" CR or LF
[Name] Defining the message
[Format] ASCII ESC / n
Hex 1B 2F n
1 ≤ n ≤ 10
[Range]
[Description] This command can define up to a 50-byte message in one line. If the value of
n is specified beyond the range, the data following n will be treated as the print
data. Once the message is defined, it remains valid until it is redefined. The
data should end with CR (0DH) or LF (0AH). If the data exceeds 50 bytes, the
subsequent data will be treated as the print data. Once the message is
defined, it remains valid until it is redefined or the download deletion command
(ESC DC2 n1 n2) is executed.
5-139