JVC SW-D7000U Instruction Manual page 71

SW-D7000U, 9CH. COLOR VIDEO MULTIPLEXER
NOTE: To ensure optimum system performance this feature should not be used as a substitute
for correctly setting camera video levels.
CAMERA DISABLE
If a camera is not installed then the continual display of the on-screen VIDEO LOSS indicator "V", for
a cameo or VDL for a full-screen, can distract an operator.
In addition, unnecessary time must be spent to remove the camera from the sequence lists and the
record lists. The SW-D7000U takes care of this situation with one setting.
The SW-D7000U allows the programmer to set inactive cameras as "DISABLED" via a menu setting,
so that video loss indications are not shown.
removed from all programmable sequence lists and the Record List.
cameras, which are not installed, this feature is also very useful when a camera is undergoing
maintenance, or has a temporary fault.
NOTE: The disabled setting does not affect cameras shown on Monitor-A during Play mode.
" Individual Disable - provides a listing of each camera that can be disabled or enabled
individually.
" Power Up Disable - if activated, causes the multiplexer to automatically disable cameras
whose sync or video level are not present on the video inputs.
" Auto Disable Now - will automatically disable cameras whose sync or video levels are not
present on the video inputs.
COVERT CAMERA
This menu item allows for cameras to be removed from the LIVE display view without affecting the
recording of the camera for review at a later time. In this way, operators or subjects will not be aware
of cameras being recorded.
Camera Scope
This menu item provides a camera scope representing the incoming analog camera video signal. To
JVC PROFESSIONAL, IMAGING PRODUCTS
Signal Gain Set-up
Camera
Gain
[CANCEL] [OK]
In addition, disabled cameras are automatically
Individual Disable
Power Up Disable
Auto Disable Now
Exit
Covert Camera
Camera 01 :NO
Camera 02 :NO
Camera 03 :NO
Camera 04 :NO
Camera 05 :NO
Etc.
[CANCEL] [OK]
:01
:05
Besides being used for
71