Cleaning - Mitsubishi Electric NJ-EXSA10JH Instruction Manual

Tips

Cleaning

Clean the Parts after Use Every Time
Cartridge
<Clean the cartridge after it has cooled down>
Rinse it with water and then wipe off the water.
* Do not wash it with the nylon surface of a cleaning
sponge (doing so may cause damage).
How to remove the
cartridge
First remove the heat
sink.
1
Remove it while
holding the tab.
Tab Tab
2
Release the 3 locks
(release the part).
3
Open the cartridge.
Cartridge Packing Cartridge Packing
4
Remove the cartridge packing.
Release from Release from
here here
How to attach the cartridge
1
Attach the cartridge
packing.
* Do not attach the packing
by twisting it (doing so
may cause steam to leak).
2
Insert the 4
claws into the
holes and close
the cartridge.
3
Engage the 3 locks.
4
Confirm that the cartridge
has a bush (see the figure
below) and attach the
cartridge to the main unit.
Insert the lower part and
then push in the upper part.
If you do not attach the cartridge, the heat sink cannot be attached.
How to attach the bush
Bush Bush
Attach the bush correctly.
Not doing so may cause
boiling over.
Before cleaning, pull out the power plug, remove the main unit plug, and then wait until the main unit cools.
Wash it Wash it
thoroughly thoroughly
to ensure to ensure
tasty rice. tasty rice.
Packing Packing
(cannot (cannot
be be
released) released)
Lock Lock
Insert the packing into the Insert the packing into the
groove so that the circular groove so that the circular
surfaces of the packing are surfaces of the packing are
Hole Hole at the top and bottom. at the top and bottom.
Claw Claw
Lock Lock
Tank
<Clean the tank after it has cooled down>
Tank lid and tank container:
Rinse it with water and then wipe
off the water.
* Do not scratch the water level
sensor surfaces (inside and
outside)
Tank cover:
Wipe it with a well-wrung-out cloth.
How to remove the tank
1
Remove the tank from
the main unit.
2
Remove the tank lid
(remove it while holding the
Pipe
Clean the
inside of the
pipe as well.
Check Valve
(inside the pipe)
Do not remove this part.
* Do not pull or turn the check
valve (doing so may cause steam
to leak).
3
Drain the water.
4
Place the tank on a
cloth and remove
the tank cover.
Hold the tank cover with
both hands and push it downward.
How to attach the
Align the 4 Align the 4
protruding parts protruding parts
tank
at the tank bottom at the tank bottom
and push into the and push into the
1
Attach the tank
main unit. main unit.
cover to the
tank container.
2
Attach the tank lid.
3
Insert the tank into
the main unit.
Water level sensor Water level sensor
part).
End
of the
Pipe