Canon iPF9000S Troubleshooting Manual page 30

Panel display
Code
(last 4
Large LCD
digits)
2500 Ink tank is empty.
to Press OK and
250C replace ink tank.
No ink left.
Replace ink tank.
2510 Ink level is
to unknown.
251C Check ink level.
Press Online to start
printing.
2520 No ink tank
to loaded.
252C Press OK and
check ink tank.
No ink tank
loaded.
Check ink tank.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
No Ink
Left
↓↓↓
↓↓↓
Online Ink Lvl
Key Unknow
Press To n
Print Press
Online
Ink Tank No Ink
Check XX Tank
Check
Ink Tank
Explanation/Detection sequence
Ink tank empty (continued use not allowed)
The ink tank has run out of ink. (The
reserved volume of ink is put to use after the
remaining ink falls below the pin check
level.)
(In the small LCD, the arrow ↓ points to
the color in question.)
The last 2 digits signify applicable colors.
00:Bk, 01:Y, 02:M, 03:C, 04:PM, 05:PC, 06:MBk1,
07:MBk2, 08:GY, 09:PGY, 0A:R, 0B:V, 0C:GR
Remaining ink level unknown (continued
use allowed)
The level of ink remaining in the tank is
detected when the tank cover is closed.
Consumption has exceeded the original ink
capacity (mismatch detected).
Refill ink may have been used.
(In the small LCD, the arrow ↓ points to
the color in question.)
The last 2 digits signify applicable colors.
10:Bk, 11:Y, 12:M, 13:C, 14:PM, 15:PC, 16:MBk1,
17:MBk2, 18:GY, 19:PGY, 1A:R, 1B:V, 1C:GR
Ink tank not installed (continued use not
allowed)
On a model that is furnished with a subtank,
this error is indicated if the subtank has run
out of ink and the state of an ink tank not
being installed is detected.
The last 2 digits signify applicable colors.
20:Bk, 21:Y, 22:M, 23:C, 24:PM, 25:PC, 26:MBk1,
27:MBk2, 28:GY, 29:PGY, 2A:R, 2B:V, 2C:GR
2-18
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Replace the
tank.
②If the problem
persists after
the tank has
been replaced,
the remaining
ink detection
system is at
fault (replace
the supply unit
or check the
bundled wires).
Replace the ink
tank.
①Remove and
then reinstall
the tank.
②Replace the
tank.
③Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)