Canon iPF9000S Troubleshooting Manual page 24

Panel display
Code
(last 4
Large LCD
digits)
2015 Cannot cut paper.
Press Load/Eject
and reload the
paper.
Cannot cut paper.
Reload the paper.
Cannot cut paper.
Lift the release
lever and reload
the paper.
Paper cutting
failed. Lift the
release lever.
2016 No sheets.
Press Load/Eject
and reload the
paper.
No sheets.
Lift the release
lever and reload the
sheets.
The paper is too
small.
Check paper size.
Sheet removed.
Lift the release
lever.
Paper jam.
Press Load/Eject and
reload the
paper.
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
Cannot feed paper
Lift the release
lever and reload
paper.
Cannot feed paper.
Reload the paper.
Cannot feed paper.
Press Load/Eject
and reload the
paper.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
Cutting Press
Error ↑ Key
Please to
Cut Papr Release
Paper
Sheets Sheet Not
Please Loaded
Load
Paper Jam
Press ↑
Key
Paper Jam Paper
Press ↑ Eject Err
Key Remove
Paper
Explanation/Detection sequence
Cutting failure/jam detected due to a cutting
failure
An idle cutter unit or a cutter blade that is too
blunt to cut sheet has been detected by the
paper leading edge detection sequence.
Paper loosened out of position while printing
The trailing edge of paper has been detected
at least 20 mm shorter than the length of cut
forms detected.
Jam while picking up, ejecting or printing on
paper
(A sequence of removing jams with the pinch
roller released is required)
Virtually all recovery errors that could occur in
connection with paper pickup are handled.
2-12
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Go to ★2015
(P3-17).
Go to ★2F24
(P3-18).
Reload the paper.
Go to ★2E27
(P3-14).
①Open and
close the
release lever to
reload the
paper.
②Remove the
paper once
and then
refeed it.
★Go to 2E27
(P3-14)