Canon iPF9000S Troubleshooting Manual page 22

Panel display
Code
(last 4
Large LCD
digits)
200D Paper size not
detected.
Press Load/Eject
and reload the
paper.
Leading edge
detection error.
Lift the release
lever and align
leading edge
with orange line.
Paper size not
detected.
Lift the release
lever and reload
the paper.
Paper size not
detected.
Reload paper.
200E This paper
cannot be used.
Check supported
paper sizes.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change
Paper
Troubleshooting Guide
Small Small
LCD 1 LCD 2
Paper Size
Please Undetect
Reload ed
Press
↑ Key
Paper Paper
Size Too
Please Small
Check Press
↑ Key
Paper Paper
Size Too
Please Small
Check Press
↑ Key
Explanation/Detection sequence
Paper size detection failure
Cannot detect the trailing edge of the paper.
・Cannot detect the trailing edge of the cut
sheet loaded after they have been fed 50
mm.
・Cannot locate the trailing edge of the paper
that has been found by coarse detection.
Paper is too small
The width and length of paper detected are
shorter than the supported size (1.5%
margin).
2-10
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Check to see if
roll paper are
not loaded in
the cut sheet
mode.
②Load cut
sheet. Go to
★2010
(P3-12)
①Check paper
conditions
(soiling,
tear-offs,
residual paper
chips, residual
trimming cuts,
folds)/size.
②Has the paper
been fed
successfully
(without
slippage under
a load or any
influence)?
③Has the LF
adjustment
value set
correctly?
④Hasn't the
loaded paper
shrunk to
below its
margin in the
particular
environment?
Go to ★
2017/2018 (P3-12)