Canon iPF9000S Troubleshooting Manual page 21

Panel display
Code
(last 4
Large LCD
digits)
1410 No ink tank
to loaded.
141C Check ink tank.
200A Paper size not
detected. Press
Load/Eject
and reload the
paper.
Paper size not
detected. Reload
paper.
Paper size not
detected. Press OK
and
reload the paper.
200B Paper size not
detected. Reload
paper.
200C Paper size not
detected.
Press Load/Eject
and reload the
paper.
Paper size not
detected.
Reload paper.
Paper size not
detected.
Lift the release
lever and reload
the paper.
Small Small
LCD 1 LCD 2
Ink tank not installed (continued use allowed)
The ink tank is not installed but a sufficient
volume of ink is left in the subtank.
Displayed only on models having a subtank.
This occurs in cases such as when the ink
tank cover is opened during printing, and the
ink tank is removed. (XX： Displays
applicable colors)
Last 2 digits: 10:Bk, 11:Y, 12:M, 13:C, 14:PM,
15:PC, 16:MBk1, 17:MBk2, 18:GY, 19:PGY,
1A:R, 1B:V, 1C:GR
Paper Size Paper size detection failure
Please Undetect Cannot detect the paper width (poorly
Reload ed positioned paper).
Press
↑ Key
Paper Size Paper size detection failure
Please Undetect Paper is invalidly positioned on the platen.
Reload ed
Press
↑ Key
Paper Size Paper size detection failure
Please Undetect Cannot detect the leading edge of the paper.
Reload ed The leading edge of paper has been located
Press by coarse detection but not by a second
↑ Key round of fine detection (up to 300 mm)
(semi-transparent paper).
(This is the message when the release lever
operation is not necessary.)
Papr Size Press Paper size detection failure
Undetecte Online Cannot detect the leading edge of the paper.
d Key The leading edge of paper has been located
and by coarse detection but not by a second
Reload round of fine detection (up to 300 mm)
(semi-transparent paper).
Explanation/Detection sequence
2-9
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Mount the tank.
②Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)
Go to ★2010
(P3-12)
Go to ★2010
（P3-12）
Go to ★2010
(P3-12).