T-Top - PURSUIT 2870 Center Console Owner's Manual

CONSOLE COOLER
A molded insulated cooler is installed under the front seat of the console. The cooler drains to the cockpit
sole and then overboard through the cockpit drain system. The cooler should be cleaned thoroughly after each
use.
BOW STORAGE COMPARTMENT
There are three storage compartments located in the bow. The port and starboard compartments have rod racks
and additional room for dunnage. The center compartment provides access to the water and holding tanks
and has additional room or dunnage.
ROD LOCKERS
There are two lockable rod lockers located in the bow above
the port and starboard storage compartments. The lockers
are designed to store and secure three rods each and are
equipped with straps to secure the rods during boat opera-
tion. Always make sure the rods are properly secured in the
storage rack before operating the boat.
FOLDING AFT SEAT (Optional)
The seat will lock into place as it is lifted into position. Lockable Rod Locker
Before using, ensure that both supports are locked. To store
the seat, simultaneously depress the latch on each seat support and fold the seat down. Support the seat as you
release the latches to prevent the seat from falling unexpectedly.

7.4 T-Top

The T-top is made of welded anodized aluminum and is designed to accommodate radio antennas, radar
antennas and navigation lights. It is equipped with an overhead storage compartment for life jackets and other
soft, light items and an overhead light activated by a switch in the helm. It could also be equipped with optional
outriggers and/or rod holders.
The T-top is not designed to support the additional weight of items like an instrument locker or a life raft.
Radar and electronics antennas must be mounted near the center section of the T-top in the area above the legs.
Do not mount any antennas or equipment to the brow area forward of the front legs or to the rear of the top.
The T-top is not design to support the weight of accessories in these areas.
The warranty for the T-top will be void if the top is modified in any way or heavy accessories like life rafts,
or electronics lockers are mounted to the top. Additionally, if items like radar antennas, spotlights and other
accessories are mounted in the wrong location, the warranty could be void. If you intend to add equipment
or make modifications to the T-top, you should contact Pursuit Customer Relations to make sure the equipment
you would like to add or the intended modification will not void the warranty on the T-top.
If an after market T-top is installed, it must be designed with front legs that are bolted to the console on either
side of console seat and the rear legs bolted to the cockpit sole at the rear of the console. There are aluminum
plates or wood reinforcement in the laminate in these areas for securing the T-top leg bases. Both front and
rear legs should also have brackets that are thru-bolted to the console just below the windshield to provide
additional stiffening for the T-top. If you intend to install an after market T-top on your boat, please contact
your dealer or Pursuit Customer Relations.
2870 Center Console
54