Operation - Hitachi BD-W3300 Instruction Manual

In case of when abnormal situations happen
Symptoms
The power can't be
turned on
Operation stops in
the middle / Power
is turned off during

operation

Display does not appear
immediately after
turning on the power.
Operation does not
start even after pressing
the Start button
Water is discharged
upon pressing the
Start button
Water remains at the
softener inlet of the
detergent case
The Dry Filter is wet
86
Please check the following items
Is the power supply plug inserted in the power point?
Is there a power failure or the current fuse or the circuit breaker
blown?
Is there a noise generating device such as television or radio
near the machine?
Power may turn off if the noise repeatedly enters the machine.
When the temperature of the motor exceeds the specified
value, the power will be turned off for safety.
In the condition that the dry filter is blocked, the drying
operation may stop, causing the power off.
The indicator lights up in about 1 second after the "Pi Pi"
sound when the power supply button is turned on.
Have you set the timer operation?
If the machine is started with bank full stage (approximately
29L), operation will start after draining the water.
Liquid detergent and softener inlet siphons off water, as a
result of which water remains in the detergent case.
Is the cap removed?
Is the machine mounted in level horizontally?
If the machine is tilted, siphoning mechanism would not
work and water in the detergent case may not be removed
sufficiently.
Did you stop the operation in the middle?
It may become wet if the drying is paused or finishes before
the laundry is dried fully.
Is the dry filter blocked?
Dry filter may become wet if it is blocked.
If it is left wet, it may cause fungus.
Insert the power supply plug in the power point.
Press power ON button to restart the operation.
Remove and insert the power plug once again and press the
power ON button to restart the operation. Do not place television
or radio near the machine.
It is not an error.
Restart the operation after approximately 1 hour.
It is not an error.
Clean the dry filter.
It is not an error.
This is because it takes a little time to start the controller board.
Cancel the timer operation to start the operation immediately.
It is not an error.
You may remove the water, wipe it off with a dry cloth or clean it if
required.
Securely fit the cap.
(Installation Manual)
Check that the air bubble of the level is in the circle.
It is not an error.
Clean the dry filter.
Remove the dry filter, and let it dry naturally.
(Continued)
Adjustment method