Sharp 13VT-K100 Service Manual page 38

13VT-K100/150
13VT-CK10
INSTALLING THE MASTER CAM (AT REAR
SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as
shown below.
2. Place the master cam in the position as shown below.
Fully turn
clockwise
Fully turn counterclockwise
Face the wide tooth side ward
Figure 1-44-1.
Note:
See the figure below for the phase matching between the
master cam and the casecon drive gear.
3. Finally fix with the E-ring.
Casecon drive gear
Round mark
When installing the master cam,
align the casecon drive gear
round mark with the half-round
notch of master cam.
Figure 1-44-2.
E-ring
(XRESJ30-06000)
Master cam
Master cam
Half-round notch
REPLACEMENT OF LOADING MOTOR
• Removal
Apply grease
Figure 1-45.
• Replacement
1. Remove the loading motor, and install the replace-
ment loading motor as shown below.
Figure 1-46.
The loading motor pressing-in must be less than 14.7
N (15 gf).
Adjust the distance between motor and pulley to 10.2
+0.2
mm).
–0.2
38
Apply grease
No grease
+0.2
10.2 mm
–0.2