Changing The Cd Rom And The Memory Stick - Sony DRE-S777 Operating Instructions Manual

SETUP Display

Changing the CD ROM and the Memory Stick

36
Chapter 3 Operation
To change the CD ROM without turning off the power, proceed as follows:
1
On the SETUP display, turn the jog dial to highlight "Eject CD/MS."
2
Press the F4 key.
The following pop-up window opens.
Eject CD/MS
Rev mode
Direct/Rev : CH1-2 D+REV CH3-4 D+Rev
Load
Save
SETUP
3
Press the F4 key again.
The CD tray opens.
4
Change the CD ROM and insert the Memory Stick supplied with a CD
ROM now in use.
You need not change the Memory Stick when changing to the CD
ROM supplied with this unit if the Memory Stick currently in use is the
one supplied with the DASK-S70x series software (optional).
5
Press the F3 key.
The CD tray closes and the reverb program is loaded from the CD
ROM.
Note
The Z key does not function after the program has been started from a CD
ROM. Use the Z key when inserting a CD ROM immediately after the
power is turned on.
: Mono(1)in Stereo out
Change CDROM/MS?
:
:
Exit Enter