NEC Express5800/R320a-E4 User Manual page 75

Configuring and Removing Duplexed Setting of Disks by the RDR
Function
This section describes how to make disks duplex and how to remove the settings by using the RDR
function. To use the RDR function, use [RDR Utility].
About RDR Utility
Starting RDR Utility
From [Start], select [All Programs] then [RDR] and click [RDR Utility] to start [RDR
Utility].
Screen
[Left pane]
The tree shows disks inserted to the built-in slots and virtual disks (RDR Virtual Disks)
created by RDR. Right-click a disk on the tree to display the menu for setting RDR. By
looking at the tree, you can know which disk corresponds to which disk of the Windows'
[Disk Management] and whether RDR is set to the disk.
For example, in the case of the disk highlighted in the figure above:
Slot0 － Harddisk1－LUN2－PLEX0
(1) Corresponds to the number of Windows' [Disk Management]. In this example, this
disk is the Disk1 on [Disk Management].
(2) Corresponds to the number of a virtual disk created by RDR setting. In this example,
this disk is a disk which makes up the RDR Virtual Disk 2 (only appears for disks
with RDR setting).
(3) This section appears only for disks with RDR setting.
(1) (2)
Windows Setup and Operation 3-5
(3)