HP ExpressCard Hardware Setup Manual page 19

2. Connect the infrared (IR) emitter cable from the IR receiver
to the set-top box.
If you did not include a set-top box in your setup, proceed to
"Step 4: Complete the
a. Connect the IR emitter cable plug to the connector on the
b. Remove the backing paper from the IR emitter to expose
c. Press the adhesive side of the IR emitter onto the infrared
Hardware Setup
remote sensor 1.
✎
Be sure that you connect the IR emitter cable plug to the
connector marked with a "1" on the remote sensor.
the adhesive tape 2.
(IR) lens on the front of the set-top box 3.
✎
To help locate the IR lens, shine a flashlight on the front
of the set-top box. The IR lens is usually a small, dark
red window.
✎
If you cannot place the emitter directly over the IR lens,
place it as close to the IR lens as possible.
setup," later in this chapter.
TV tuner setup
3–9