2.7 Jumper Settings
Jumper Configuration
Configure the jumpers based on the number of hard drives installed in the unit.
Do not throw away unused jumpers.
See section 2.2 to locate this block of jumpers.
After any drives are installed, replaced or removed, the Reset Disk
NOTE
Failure command must be run from the Supervisor Menu for the
changes to be recognized by the DVSe.
DVSe
2-6 Drives
Load 4
Load 3
Load 2
Load 1
8 Drives
Load 4
Load 3
Load 2
Load 1
14
0150-0178H