GE Digital Video Storage System User Manual page 13

Connect the hard
drives to the power
supply connectors
with power supply
cables.
When connecting a
single drive to a
cable, attach the
drive to the
connector at the end
of the power cable.
NOTE
The diagram above shows a typical connection. The connections
may vary according to the number of drives in the system and the
power cable type.
IDE Data Cables
Use an IDE cable to connect the drives as shown in the diagram in section 2.3.
When attaching the IDE connector, make sure the connectors are oriented
properly.
Connecting To The Motherboard
The red stripe on the connection ribbon
should connect nearest the Pin 1 indicator
on the motherboard.
Connecting To The Hard Drive
The red stripe on the connection ribbon
should connect near the jumpers on the hard
drive.
0150-0178H
Mother Board
13
Power Supply
Pin 1
Indicator
Pin 1 Near
Jumpers
DVSe