Panasonic 308 Installation Instructions Manual page 55

Section 400
S-DBS Programmin
Issue 1 July 1990
g Instructi+3In.
.
HOW TO PROGRAM WITH A DATA TERMINAL
At the REMT> prompt press "H" for help.
The screen will prompt you to select from the Maintenance Mode menu:
P = Program
Set
S = Speed,Dial Set
Control 2 =
33xit
If you enter ,P" (P plus return) the screen will display the following:
REMT> P
DBS
System Prog
Rag>
At the
Rag>
prompt press
"H".
The screen will display the PSI) Key set-s
menu and the Rag>
followed by number o F
rompt again. At the
Rag>
prompt press the Tilde key (-)
the setting, for example, "-01" for System
programming and press return.
At the
01
Sys> prom t press return again. The fast address in the system. (the
date) will appear on % e screen:
. ~- _~.___. __. ~_.
SO001 900809 -D)
The screen will advance to the next address every lime you press return or you
can change the date in address '0001" from August 8, 1990 to August 10. 1990,
for example, by entering (press return) 900810.
The screen will advance to the next address. To check that the date is entered
correctly press
'Control E"
to bring you back to the previous address which in
our example is '0001".
Pressing "H" for help at any stage will access control key menus and other infor-
mation to help you move from port to port or address to address, access a menu,
return to a previous operation or exit.
.
b
----
s
11
3
'3