Nokia 6310i User Manual page 16

• bbb
• ccc
• ddd
• e, g, i
• f, h, j
Neighbours 1 - 3 are affected by multiband reporting parameter
(see FTD 7). There will be 0 - 3 neighbours from the other band first
and the remaining places will be filled with neighbours from this
band in order of RX level.
The following is a quote from Phase 2+ ETSI GSM 05.08 version
5.4.0, section 8.4.3 'Additional cell reporting requirements for
multiband MS':
For a multi-band MS the number fo cells, for each frequency band
supported, which shall be included in the measurement report is
indicated by the parameter, MULTIBAND_REPORTING. The meaning
of different values of the parameter is specified as follows:
Value Meaning
0 (00) Normal reporting of the six strongest cells, with known
and allowed NCC part of BSIC, irrespective of the band
used.
1
(01) The MS shall report the strongest cell, with known and
allowed NCC part of BSIC, in each of the frequency bands
in the BA list, excluding the frequency band of the serving
cell. The remaining positions in the measurement report
shall be used for reporting of cells in the band of the
serving cell. If there are still remaining positions, these
shall be used to report the next strongest identified cells
in the other bands irrespective of the band used.
C1 value, range is -99 - 999, displayed only in idle
mode.
Instead of C1 value, letter 'B' and BSIC value is
displayed in active mode.
RX level in dBm, - sign is not shown if ccc<=-100
C2 value, range is -99 - 999
F is shown if the cell is in a forbidden location area,
otherwise the location is empty
B is barred, N is normal priority and L is low priority,
otherwise the location is empty
14