Cub Cadet Tank S S7232D Operator's Manual page 43

Problem
Entire electrical system does
not work
Dead battery
Battery will not take a
charge
Battery light comes on
when the engine is running
Indicator lights do not come
on when key switch is in
START position
Excessive vibration
Uneven cut
Mower will not mulch grass
(If Equipped w/Mulching Kit)
Cause
1. Blow fuse.
2. Loose or corroded connections.
3. Sulfated or worn out battery.
1. Shorted starter solenoid.
2. Key switch not turned to stop position.
3. Sulfated or worn out battery.
1. Dead battery.
2. Loose or corroded connections.
3. Sulfated or worn-out battery.
1. Low engine speed.
2. Faulty voltage regulator.
3. Faulty battery.
4. Faulty alternator.
5. Grounded wire in circuit.
1. Faulty bulbs.
2. Faulty wiring.
3. Faulty sensor.
1. Cutting blade loose or unbalanced.
2. Damaged or bent cutting blade.
1. Deck not leveled properly.
2. Dull blade.
3. Uneven tire pressure.
1. Engine speed too low.
2. Wet grass.
3. Excessively high grass.
4. Dull blade.
Remedy
1. Replace the fuse.
2. Repair or replace the connections.
3. Clean the battery terminals or replace the
battery.
1. Replace the solenoid.
2. Turn the key switch to the stop position.
3. Clean the battery terminals or replace the
battery.
1. Replace the battery.
2. Tighten or replace the connections.
3. Clean the battery terminals or replace the
battery.
1. Increase the engine speed.
2. Replace the voltage regulator.
3. Replace the battery.
4. Replace the alternator.
5. Repair the wire.
1. Replace the bulbs.
2. Repair and/or replace the wiring.
3. Replace the sensor.
1. Tighten blade and spindle.
2. Replace blade.
1. Perform side-to-side deck adjustment.
2. Sharpen or replace blade.
3. Check tire pressure in all four tires.
1. Place throttle in FAST (rabbit) position.
2. Do not mulch when grass is wet.
3. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting swath.
4. Sharpen or replace blade.
s 9 — t
ectiOn rOubleshOOting
43