Safety Interlock System; Starting The Engine - Cub Cadet Tank S S7232D Operator's Manual

c. Examine the belts for cuts, fraying, and excessive
wear. Replace if any of these are detected.
d. Replace the deck cover.
8. Check if deck is level. When correctly adjusted the mower
deck should be level side to side, and the front of the deck
should be approximately 1⁄4" lower than the rear of deck.
If deck needs to be leveled, refer to the Maintenance &
Adjustments section.
9. Lubricate all pivot points listed in the Maintenance &
Adjustments section.
10. Adjust the seat for operator's maximum comfort, visibility
and for maintaining complete control of the tractor. Refer
to the Assembly & Set-Up section for instructions on
adjusting the seat.

Safety Interlock System

This tractor is equipped with a safety interlock system for the
protection of the operator. If the interlock system should ever
malfunction, do not operate the tractor. Contact your authorized
Cub Cadet Dealer.
• The safety interlock system prevents the engine from
cranking or starting unless the speed control pedals are in
the neutral position, the parking brake is engaged, and the
PTO is disengaged.
• To avoid sudden movement when disengaging the parking
brake, the safety interlock system will shut off the engine
if the speed control pedals are moved to a position other
than the neutral position when the parking brake is
engaged.
• The safety interlock system will shut off the engine if the
operator leaves the seat before engaging the parking
brake.
• The safety interlock system will shut off the engine if the
operator leaves the seat with the PTO engaged, regardless
of whether the parking brake is engaged.
NOTE: The PTO switch must be moved to the "OFF"
position to restart the engine.

Starting the Engine

WARNING!
interlock system designed for the protection of the
operator. Do not operate the tractor if any part of
the interlock system is malfunctioning. Periodically
check the functions of the interlock system for
proper operation.
WARNING!
be sitting in the tractor seat when starting the
engine.
1. Open the fuel shutoff valve by selecting the left or right
tank position.
2. Sit on the Seat. Set the parking brake.
3. Make sure the speed control pedals are in the neutral
position.
4. Turn the PTO switch "OFF".
18 s 5— O
ectiOn peratiOn
This tractor is equipped with a safety
For personal safety, the operator must
5. Push the throttle control to a position a third of the way
between slow and fast.
6. Insert the key in the ignition and start switch, turn the
switch to "RUN", and wait for the glo-plug light to go out.
7. Turn the ignition key in a clockwise direction to the "START"
position until the engine starts.
NOTE: Do not hold the key in the "START" position for more than
10 seconds or you may damage the starter. If the engine does not
start in this time, wait about 30 seconds and try again.
Cold Weather Starting
When starting the engine at temperatures near or below
freezing, ensure the correct viscosity motor oil is used in the
engine and the battery is fully charged. Start the engine as
follows:
1. Be sure the battery is in good condition. A warm battery
has much more starting capacity than a cold battery.
2. Use fresh fuel. Do not use fuel left over from summer.
3. Follow the previous instruction for Starting the Engine.
Using Jumper Cables To Start Engine
WARNING!
Batteries contain sulfuric acid and
produce explosive gasses. Make certain the area is
well ventilated, wear gloves and eye protection, and
avoid sparks or flames near the battery.
If the battery charge is not sufficient to crank the engine,
recharge the battery. If a battery charger is unavailable and
the tractor must be started, the aid of a booster battery will be
necessary. Connect the booster battery as follows:
1. Connect the end of one cable to the disabled tractor
battery's positive terminal; then connect the other end of
that cable to the booster battery's positive terminal.
2. Connect one end of the other cable to the booster
battery's negative terminal; then connect the other end of
that cable to the frame of the disabled tractor, as far from
the battery as possible.
3. Start the disabled tractor following the normal starting
instructions previously provided; then disconnect
the jumper cables in the exact reverse order of their
connection.
4. Have the tractor's electrical system checked and repaired
as soon as possible to eliminate the need for jump starting.