Front Bezel - NEC Express5800 User Manual

Front Bezel

The front bezel must be removed to install or remove the 5.25-inch device and hard disk drive cage.
Removal
Follow the procedure below to remove the front bezel.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the side cover as described earlier in this chapter.
3.
Pull the release tabs (3 places) at the left end of the front bezel toward you ( ) so that the
tabs are removed from the frame of the server ( ), as shown in the figure below.
IMPORTANT: If the tabs are pulled out toward you excessively, the
hooks fixing the right end of the front bezel will be damaged. Only pull
out the tabs a little.
1
2
1
1
Upgrading Your Server 9-9