Hands-Free Phone Control; Preparing The Remote Control Unit; Changing The Battery Of The Remote - Kenwood KIV-BT901 Instruction Manual

Hands-free phone control

Making a call
• Enter the dialing method selection mode: [ ]
• Select a dialing method: [ENT]
• Number dial input:
Input a digit: [0] – [9]
Input "+": [¢]
Input "#": [FM+]
Input "*": [AM–]
Clear the entered phone number: [4]
• Make a call: [DIRECT]
Receiving a call
• Answer the call: [ ]
• Switch between the private talk mode and the
hands-free talk mode: [ENT]
Call waiting
• Answer Another Incoming Call with the Current
Call Suspended: [ ]
• Answer another Incoming Call after Terminating
the Current Call: [SRC]
• Continue the Current Call: [1]
During a call
• End the call: [SRC]

Preparing the remote control unit

Pull the battery sheet out from the remote control
unit to the direction of the arrow.
Changing the battery of the remote control
unit
Use a commercially available
Push on slide
button battery (CR2025).
Insert the battery with the +
and – poles aligned properly,
CR2025
following the illustration
Pull out
(+side)
inside the case.
¤
CAUTION
• Do not set the remote control in hot places such
as on the dashboard.
• Lithium battery.
Danger of explosion if the battery is incorrectly
replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be exposed
to excessive heat such sunshine, fire or the like.
• Keep battery out of reach of children and in
original package until ready to use. Dispose of
used batteries promptly. If swallowed contact
physician immediately.
69
|
English