Lan Cable Connection (For Iscsi 1Gbit/S) - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 4 Connecting Cables
4.2 Host Interface Connection
1-2
Insert the Copper Twinax cable connectors in the host interface ports (iSCSI 10Gbit/s or FCoE) of
Controller 0 (CM#0) and Controller 1 (CM#1).
2
Connect the connector at the other end of the Copper Twinax cable to the connection
destination.
2-1
If the Copper Twinax cable connectors have covers, remove the covers.
2-2
Insert the Copper Twinax cable connector to the connection destination.
4.2.3

LAN Cable Connection (For iSCSI 1Gbit/s)

Connect the ETERNUS DX Disk storage system to the connection destination with LAN cables (enhanced Cat-5
type).
LAN cables must be obtained separately.
• When using iSCSI connections via LAN switches for connecting to the server, using different LAN switches
to divide the networks is recommended for connecting the server and the ETERNUS DX Disk storage
system and for operation management in order to maintain system performance.
• The iSCSI interface operates in 1000Base-T full-duplex mode.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Do
CAUTION
• When connecting the Copper Twinax cables, position them so that they
will not obstruct replacement of the power supply unit or controllers by
the maintenance engineer.
Copyright 2013 FUJITSU LIMITED
70
End of procedure
P3AM-4832-07ENZ0