Table of Contents
Advertisement
Paper is not Fed into the Printer (part 1)
If you encounter paper loading problems, refer to the check list below.
Reference:
Paper Jam
CHECK1
Is there too much paper in the paper tray?
Paper tray can hold up to 150 sheets of 75g/m
plain paper. Be sure to keep total thickness of the
loaded paper stack below 15mm. The bypass tray can
hold 1 sheet of paper only. If too much paper is loaded
into the paper tray, paper supply problems will occur.
Remove some of the paper from the paper tray.
CHECK2
Is the top of the following paper fed into the
printer?
If overlapping pieces of paper are supplied to the
printer, paper supply problems will occur. Fan the
paper before loading into the printer.
CHECK3
Is the paper guide correctly adjusted to fit
the paper?
If the width of the guide is set too narrow, a paper
supply problem will occur. If the width of the guide is
set too wide, printout will be skewed. Ensure that the
guide is adjusted correctly to the paper.
How to Use the
Printer Properties
Online Manual
CHECK4
2
(20 lbs.)
CHECK5
Paper
Banner
Envelope
Card
CHECK6
Print Status
Print
Window
Is the bypass tray and the paper knob set
to the appropriate position for thick paper?
When loading thick paper through the bypass tray,
open the bypass tray until it reaches position 2 (the tray
has two stop positions), and turn the paper knob to
(
) setting.
Is the loaded paper too thick or too thin?
Use only paper that meets SHARP specifications for
weight as shown below.
Type
2
60g/m
to 200g/m
(16 lbs. to 110 lbs. index)
2
75g/m
(20 lbs.)
2
75g/m
to 90g/m
(20 lbs. to 24 lbs.)
2
110g/m
to 200g/m
Max. thickness: 0.3mm (0.012")
Trouble feeding stiff envelope or heavy
paper?
Feed them one at a time through the bypass.
Sharing Printer
Maintenance
Troubleshooting
Specifications
2
2
2
(110 lbs. index)
48
Troubleshooting
Advertisement
Table of Contents
