Table of Contents
Advertisement
Paper is not Fed into the Printer (part 1)
If you encounter paper loading problems, refer to the check list below.
Reference:
Paper Jam
CHECK1
Is there too much paper in the paper tray?
Paper tray can hold up to 150 sheets of 75g/m
plain paper. Be sure to keep total thickness of the
loaded paper stack below 15mm. The bypass tray can
hold 1 sheet of paper only. If too much paper is loaded
into the paper tray, paper supply problems will occur.
Remove some of the paper from the paper tray.
CHECK2
Is the top of the following paper fed into the
printer?
If overlapping pieces of paper are supplied to the
printer, paper supply problems will occur. Remove all
the paper from the paper tray, fan, and then load them
again.
CHECK3
Is the paper guide correctly adjusted to fit
the paper?
If the width of the guide is set too narrow, a paper
supply problem will occur. If the width of the guide is
set too wide, printout will be skewed. Ensure that the
guide is adjusted correctly to the paper.
How to Use the
Online Manual
2
(20 lbs.)
Printer Properties
CHECK4
Is the bypass tray and the paper knob set
to the appropriate position for thick paper?
When loading thick paper through the bypass tray,
open the bypass tray until it reaches position 2 (the tray
has two stop positions), and turn the paper knob to
(
) setting.
CHECK5
Is the loaded paper too thick or too thin?
Use only paper that meets SHARP specifications for
weight as shown below.
Type
Paper
60g/m
(16 lbs. to 110 lbs. index)
Banner
75g/m
Envelope
75g/m
(20 lbs. to 24 lbs.)
Card
110g/m
Max. thickness: 0.25mm (0.010")
CHECK6
Trouble feeding stiff envelope or heavy
paper?
Feed them one at a time through the bypass.
Print
Maintenance
Troubleshooting
Specifications
2
2
to 200g/m
2
(20 lbs.)
2
2
to 90g/m
2
2
to 200g/m
(110 lbs. index)
44
Troubleshooting
Advertisement
Table of Contents
