Paper Is Not Fed Into The Printer - Sharp AJ-1100 Online Manual

Paper is not Fed into the Printer (part 1)
If you encounter paper loading problems, refer to the check list below.
Reference: Paper Jam
CHECK1 Is there too much paper in the paper tray?
Paper tray can hold up to 100 sheets of 75g/m
plain paper. Be sure to keep total thickness of the
loaded paper stack below 10mm. If too much paper is
loaded into the paper tray, paper supply problems will
occur. Remove some of the paper from the paper tray.
Paper type Capacity
Plain paper 100 sheets
80 sheets
Card 20 sheets
Envelope 20 sheets
Transparency 20 sheets
T-shirt transfer 1 sheet
Banner 1 sheet
Printer Driver Settings
How to Use the
Online Manual
Windows 95/98/Me/NT4.0 Windows 2000/XP
2
(20 lbs.)
Note
2
With 75g/m (20 lbs.) plain paper
2
With 80g/m (21 lbs.) plain paper
Use SHARP recommended OHP films
Maximum 5 sheets of banner paper
can be used
Print
CHECK2 Is the top of the following paper fed into the
printer?
If overlapping pieces of paper are supplied to the
printer, paper supply problems will occur. Remove all
the paper from the paper tray, fan, and then load them
again.
CHECK3 Is the paper guide correctly adjusted to fit
the paper?
If the width of the guide is set too narrow, a paper
supply problem will occur. If the width of the guide is
set too wide, printout will be skewed. Ensure that the
guide is adjusted correctly to the paper.
CHECK4 Is the tray at the correct angle?
If using banner paper, envelopes, cards or thick paper,
open the paper tray so that it is nearly horizontal
(position 2). (The tray has two stop positions.)
Print Status
Sharing Printer
Window
Troubleshooting
67
Maintenance Troubleshooting