Related Manuals for Duratrax Raze
Summary of Contents for Duratrax Raze
- Page 1 ® ™ ™ ® ASSEMBL Y AND OPERA TION MANU ASSEMBL Y AND OPERA TION MANU .duratrax.com .duratrax.com...
-
Page 2: Alkaline Batteries
ITEMS ITEMS INCLUDED INCLUDED The following items are included in the box. Chassis 250 cc Fuel Bottle Body 2° and 3° Toe-Blocks Body Clips (Qty 2) Ride Height Clips Decal Sheet Glow Starter Transmitter Instruction Manual Transmitter Antenna Exploded View/Parts Listing Receiver Antenna Tube Engine Tuning DVD WILL... -
Page 3: Warranty
When the safety precautions are followed, the we will send you a FREE replacement. Please Raze will provide years of enjoyment. Use see the Raze parts list for the items covered care and good sense at all times when under the Stress-Tech guarantee. -
Page 4: Transmitter Preparation
FINISHING FINISHING THE RAZE THE RAZE TRANSMITTER PREPARATION • Install eight “AA” batteries into transmitter, making sure the polarity is correct. • Insert the antenna into the top of the transmitter and tighten. • Turn the transmitter on and check the battery light. -
Page 5: Receiver Antenna Installation
GLOW STARTER BATTERY RECEIVER ANTENNA INSTALLATION • Uncoil and straighten the antenna wire. • Route the receiver antenna wire through the antenna tube. • Install the tube into the antenna mount. • Install a “C” battery (not included) into the •... -
Page 6: Body Installation
RADIO SYSTEM CHECK • Fully extend the transmitter antenna. • Turn the transmitter on, then turn the receiver on. • Turn the transmitter wheel to the right—the front wheels should turn to the right. If not, move the steering servo reverse switch. •... - Page 7 This could result in serious burns on your finger. It also causes fuel to back up in the engine, making it harder to start the next time you run your Raze. IMPORTANT! To insure long life and good performance from your engine, you MUST break-in the engine.
-
Page 8: Tuning Tips
TANK 1 “Run-on” is when the engine does not drop back down to Your first tank of fuel should be running the Raze at a very idle after the trigger on the transmitter is released. To correct rich needle valve setting. This allows the fuel to carry as... -
Page 9: Fuel System
The only real way to test a glow plug is to replace it. Make sure you have a spare plug or two on hand every time that you run the Raze. We recommend the DuraTrax Gold Plug (DTXG3005). -
Page 10: Maintenance Tips
GUIDE TIPS GUIDE BEFORE EACH RUN When tuning the Raze make sure that you have equal 1. IMPORTANT: Check to make sure lengths from one side to the other on the shocks, camber that all screws are tight. Always use rods and steering rods. - Page 11 Some basic guidelines when buggy. Rear toe-in increases the amount of traction in the setting up the Raze are that if the rear end is stiff it will give rear, but decreases steering. Decreasing rear toe-in will the buggy more steering and have less rear traction.
-
Page 12: Maintenance
MAINTENANCE MAINTENANCE GUIDE GUIDE The following section is provided to help you with maintenance and repairs to your Raze. Pay extra attention to the notes and tips for proper assembly. - Page 24 ENGINE ENGINE OUBLESHOO TING OUBLESHOO TING Copyright © 2006 V1.0 DTXZ1097 for DTXD76**...
Need help?
Do you have a question about the Raze and is the answer not in the manual?
Questions and answers