Table of Contents
Advertisement
11. Continue with "Installing Advanced System Management device drivers".
Installing Advanced System Management device drivers: You must install the
ASM device drivers for the server. The device drivers enable communication
between the Remote Supervisor Adapter and the server in which it is installed. You
can obtain the most current device drivers from http://www.sec.co.kr/server/.
The following sections describe the procedure for installing the ASM device drivers
for the server, depending on your operating system.
Notes:
1. If you are installing device drivers manually, note the following requirements:
v Make sure that the operating system is installed on the server before you
install the ASM device drivers. For information about installing the operating
system, see the documentation that comes with the operating system.
v Before installing the ASM device drivers for the Remote Supervisor Adapter,
stop any system-management application.
2. If you are using ServerGuide to install device drivers and your operating system
is Windows 2000, ServerGuide installs the ASM device drivers automatically.
v Windows 2000: Continue with "Installing Windows 2000 ASM device drivers"
v Windows NT: Go to "Installing Windows NT ASM device drivers".
After you install the ASM device drivers, go to "Configuring the remote control
password" on page 42 to set the remote control password.
Installing Windows 2000 ASM device drivers: To install the ASM device drivers for
Windows 2000, complete the following steps.
Notes:
1. Do not use the Hardware Wizard to install the drivers. If the Hardware Wizard
starts itself for the installation of any System Management Driver hardware, exit
the Hardware Wizard by selecting Cancel.
2. If IBM Director, or UM Services is running on the server,
stop the system-management application before proceeding.
Complete the following steps to manually install the Windows 2000 ASM device
drivers.
1. Open a command prompt.
2. If you are installing from a diskette, type: a:\WIN2000\SETUP, where a is the drive
letter of the diskette drive.
3. If you are installing from a CD, type: d:\DD\WIN2000\SETUP, where d is the drive
letter of the DVD-ROM drive.
4. Follow the directions that display on the screen.
5. Go to "Configuring the remote control password" on page 42.
Installing Windows NT ASM device drivers: Select one of the following methods to
install the ASM device drivers for Windows NT:
v Noninteractive
The noninteractive method for installing the ASM device drivers accepts the
default values for any window prompts that appear. You are prompted to respond
only if an error occurs during installation.
v Interactive
Chapter 2. Configuring the server
41
Advertisement
Table of Contents
