Setting The Address Of The Indoor Station; Setting Of The "Standard Outdoor Station"; Setting Of The Main Indoor Station - ABB Welcome User Manual

Setting the address of the indoor station

At the indoor stations the apartment is assigned via the setting
of the address. Up to 99 apartments can be addressed within
an ABB-Welcome system. Up to four indoor stations with equal
rights can be located in each with the same address. The four
indoor stations are called when the assigned doorbell push-
button is pressed.
The address of an indoor station (e.g. "15") is set with the
aid of the rotary knobs "X10" and "X1" at the indoor stations,
where "X10" specifies the tens digit (here "1") and "X1" the
single digit (here "5"). The rotary knobs are located at the rear
or outside of the indoor stations.
Fig. 27
Several outdoor stations with identical
assignment
STATION X10 X1 STATION X10
2 0 2 2 0
Apartment 02 Apartment 01
40 Commissioning | User Manual ABB-Welcome
X1 K10 K1
1 2 0 1
Apartment 01 A
Apartment 02 B
Outdoor station
Left building

Setting of the "standard outdoor station"

For several outdoor stations in an ABB-Welcome system the
"standard outdoor station" must be set on the indoor stations.
Here the rotary knob STATION is set on the address of the
standard outdoor station – between 1 and 4. The rotary knob
is located at the rear or outside of the indoor stations.

Setting of the main indoor station

In each apartment the switch "M/S" must be activated on
one indoor station. This means "M=ON". For additional
indoor stations in the apartment the switch here must be on
"M=OFF". The switch is located on the back or outside of the
indoor stations.
K10 K1 K10
1 0 1 3 0
Apartment 01 A
Apartment 02 B
Apartment 03 C Apartment 03
Apartment 04 D Apartment 04 B
Outdoor station Outdoor station
Gateway entrance Right building
K1 STATION X10 X1
3 3 0 3
Apartment 03
A
STATION X10 X1
3 0 4
Apartment 04