HP 3PAR StoreServ 10000 Specifications page 21

QuickSpecs
Technical Specifications
Environmental Specifications
Temperature (°F/°C), 0 - 3,000 ft / 0 - 914.4 m
Temperature (°F/°C), 3,000 - 10,000 ft / 914.4 m - 3,048 m 50 - 95°F / 10 - 35°C
Altitude (ft/m) max.
Humidity (%), Non-condensing
Raised Floor
Emissions / RFI / EMI
Safety
Energy Consumption Efficiency
1
Includes 2-meter rack and two controller nodes (fully populated)
2
Maximum, Up to 10 drive magazines (40 drives) of any combination of SAS, FC or NL and up to 8 SSD magazines (32 SSD drives) per
Drive Chassis
3
Under maximum load
4
Includes power and heat dissipation specifications for the Service Processor as follows: 317 Watts, 1082 BTU/hr,
100 - 240 VAC Input Voltage, 50 - 60 Hz Frequency, and (1) IEC-320 Power Receptacle
5
Japan Green Law statement of compliance: The energy consumption efficiency value has been calculated per requirements for
Category-N Magnetic Disk Drive Units by dividing the power consumption, measured according to the definition in the Law Concerning
the Rational Use of Energy, by the storage capacity defined in the Energy Conservation Law. The efficiency value is based on a host-
maximized 10800 configuration using 600GB drives.
6
Power Distribution Unit
NOTE: Specifications are subject to change without notice.
5
(Japan Green Law)
DA - 14103 Worldwide — Version 19 — January 17, 2014
50 - 104°F / 10 - 40°C
10,000 ft / 3,048 m
20 - 80%
Recommended
FCC Class A, EN55022 Class A,EN55024: 1998, VCCI Class A
CE Mark, C-TUVus Mark, TUV GS Mark, CB Scheme with all country
deviations
0.011
HP 3PAR StoreServ 10000 Storage
Page 21