Husqvarna 36 Workshop Manual page 72

Saw 394.
Dismantle the oil pump as follows:
1. Dismantle the screw (A) so that the
spring and latch pin (B) can be
removed.
2. Lever out the pump piston (C) with the
plastic plug (D) using a screwdriver.
3. Remove the seal (E).
Saw 3120.
Undo the three bolts that hold
the oil pump and lift up the pump
by the cut-out for the adjuster
screw. Lift off the pump and
loosen the wire for manual oil
supply.
72
– English
LUBRICATION SYSTEM
Dismantle the oil pump as follows:
1. Undo the screws (A) and remove the parts as
2. Undo screw (B). NOTE! Left-hand thread.
A
shown in the figure below.
C D
B
E
B A