Husqvarna 36 Workshop Manual page 112

Saws 36, 40, 41 and 45.
Fit the four bolts under the crankcase.
Tightening torque, see "Service data".
Saws 36 and 41.
Fit the tank unit.
Fit the ignition coil and its cables.
Fit the intake manifold and the insulation wall
between the cylinder and carburettor.
Fit the following parts:
• Cylinder cover. See operating instructions.
• Spark plug. See operating instructions.
If a new piston or cylinder has been fitted the saw must be run-in for 3-4 hours with the carburettor
set to the basic settings. See the operating instructions for the saw in question.
112
– English
PISTON AND CYLINDER
Saws 40 and 45.
Carry out a pressure test as set out on the next page.
Other saws
Fit the four cylinder bolts (B).
On saw 394, connect the anti-vibration spring
(A) to the cylinder. The bolts are tightened
using a 4 mm allen key (smaller saws) or
3/16" allen key (larger saws).
B
Fit the decompression valve.
• Carburettor.
• Muffler.
A